In shot blasting treatment, the surface roughness of the workpiece is not necessarily better the rougher it is; rather, it should be controlled within a reasonable range.
1. Advantages of surface roughening
After sandblasting treatment, the surface of the metal becomes rougher, significantly increasing its surface area and thereby multiplying the attraction between the coating and the metal surface. At the same time, the rough surface provides an appropriate morphology for coating adhesion and enhances mechanical interlocking; this is highly beneficial to improving the adhesion of the coating.
![]()
2. The negative impacts of excessively high surface roughness
If the surface of the workpiece is excessively rough, the following potential hazards may arise:
- Insufficient coating thickness: When the same amount of coating is applied, an excessively rough surface can result in a lower coating thickness. This is particularly true at the wave peaks: the coating often cannot fully cover the substrate there, making it more susceptible to premature damage.
- Coating blistering and delamination: An excessively high surface roughness can cause air to become trapped in the valleys of the surface during coating application, forming bubbles, which in turn lead to premature blistering and delamination of the coating.
- Increased material consumption: To fill excessively deep anchor patterns, more coating material is often required; therefore, excessive surface roughness will lead to increased coating material consumption during the application process.
3. Scientific standards for roughness control
To balance adhesion and coating quality, the maximum roughness generally should not exceed 1/3 of the total dry-film coating thickness. It should be emphasized that 1/3 is an empirical value; it does not mean that the closer the value is to this figure, the better. The actual control should be determined comprehensively, taking into account the type of coating, the corrosive environment, design standards, and other factors. In practice, the surface roughness of the workpiece can be precisely controlled by selecting abrasives with different particle sizes and shapes (for example, coarse corundum particles can increase roughness, while fine-quartz sand can reduce it) and by adjusting the shot-peening pressure.

